General Lou Posted August 26, 2020 Share Posted August 26, 2020 Stage 64, boot and spare wheel: Firstly, the back panel from stage 62 i used to connect the two panels from this stage. Make sure that the small cylinder protruding from the bottom of the panels is facing outward. The panels clip in, so no glue or screws: Now I take the trunk panel assembly and put it onto the back of the car. It is held in place with the two cylinder bits sticking out that i mentioned earlier: Now the scissor jack screws onto the inside of the wheel, then the spare wheel lock rests on where the hub would normally go. You can tell which wheel is the spare wheel because only one of them has holes at the centre where the others have nuts: Stage complete Quote Link to comment Share on other sites More sharing options...
johnnyrotten13 Posted August 26, 2020 Share Posted August 26, 2020 trunk!!? its car not a bloody elephant....also it's boot over here Quote Link to comment Share on other sites More sharing options...
General Lou Posted September 1, 2020 Author Share Posted September 1, 2020 On 8/26/2020 at 1:17 PM, johnnyrotten13 said: trunk!!? its car not a bloody elephant....also it's boot over here Hahaha you make me laugh! I will change one of the trunks to a boot just for you 😆 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.