General Lou Posted September 21, 2021 Share Posted September 21, 2021 Stage 112, joining and detailing the third quarter of the base: Before adding the detail, I join this base section to the others by using 4 screws and a connector. The instructions say to hold the base up by using some boxes as raisers, however I personally didn't find it necessary: Now that the base is secured, I can start gluing on the details, beginning with the jaw bone. I found that it joins best if you apply some glue all the way around the jaw and not the base, then push in firmly for about 30 seconds. Following on with the spine and stone details: Finally with this stage, I thread in one of the lights from stage 111. I checked the prototype model in the Agora office and found out that the light to use here is the one with the shorter wire: Stage complete: 1 Quote Link to comment Share on other sites More sharing options...
Beamerboy Posted September 22, 2021 Share Posted September 22, 2021 Yes, Lou - the tagged, red one with the longer wire (if we abide by Stage 111 instructions) is otherwise used in Stage 113. Quote Link to comment Share on other sites More sharing options...
General Lou Posted September 22, 2021 Author Share Posted September 22, 2021 3 hours ago, Beamerboy said: Yes, Lou - the tagged, red one with the longer wire (if we abide by Stage 111 instructions) is otherwise used in Stage 113. Ah, thank you. I must have read right over that bit on stage 111! 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.