Titanic Pack 14 - Stage 76. First class smoking room.

[Mark, The Master Modeller]

Stage 76 gives us the first class smoking room.

This stage has a bit more work involved.  Start with a window frame marathon.

Once all the frames are in place you can fit the first class smoking lounge to the promenade deck.  

Note how the bulkhead fits between the service ares and the stairwell panelling.

The fitted structure should look like this.

Glue the two support frames in place.  Use tiny amounts of superglue and make sure that the frames are properly seated on the deck, or the deck above might not fit properly.

I used the end of a steel rule to make sure they are upright.  Both sides are the same.

Turn the deck over and fit the small LED board at the aft end of the deck.  The cable is connected to socket J2 on the adjacent board, 75C.

Connect a cable from J3 of board 75C to J3 of board 74C,

Connect J2 on board 74C to J1 of board 73E.

Connect J3 on board 73E to J3 on board 72A.

Connect the tester to J2 of board 72A and check that all the light work.

It looks even better with the lights out!

This completes the stage.