W196R Stage 10. Plug leads.

[Mark, The Master Modeller]

Stage 10 gives us a bracket for the valve covers and the wiring for the plug leads.

Take the valve covers supplied in stage 9 and join them with the valve cover bracket.  THey are fitted with screws from underneath.

Fit this to the engine.  It's pressed into place.

Take the two wire covers (they look like silver rods with brackets) and screw them to the eninge.  The plain ends go to the outside of the engine.

The black plastic tubes all need to be fitted now, but they all need trimming to length.  Push one end over th pin of the spark plug.

Now trim the tube to length and push the other end over the pin on the wire cover.

Repeat this for all 16 plug leads.

This completes the stage.