W196R Stage 6. The Magnetos.

[Mark, The Master Modeller]

Stage 6 gives us the magnetos.

Take magneto part a (6A) and screw the drive shaft (PTO shaft) to it.

Now screw magneto part C (6E) to the drive shaft.

Press magneto part D (6F) onto magneto part C.

Place this assembly on the engine.  The drive shaft fits in a hole in the crank case and magneto part A is screwed to the post on the engine block.

The final part of the magneto, part B (6B) is pressed into place.

The two brackets (6C) are fitted to the magnetos.

They are secured with the two pins that are pressed into the magnetos.

The magneto support is pressed into place.  However, you may wish to leave this loose as it tends to snag during subsequent assembly.

This completes the stage.