Pack 11 - Stage 89. Front wheel arches.

[Mark, The Master Modeller]

Stage 89 gives us the rear body bulkheads and the left rear light, but we fit the front wheel arches.

You will need the front wheel arches supplied in stages 82 & 83 along with the screws supplied in stage 85.

The wheel arches need to be flexed slightly to get them into position.  Insert the front end first then you'll be able to get the rear end to snap into place.

The front end of the wheel arch is held with 1 screw.

The rear end is held with 2 screws.

Repeat with the other wheel arch.

Fit the tyre to the wheel.  These parts were supplied in stage 86.  No need to soften the tyre with hot water, the rubber is soft enough to flex over the wheel rim.

This completes the stage.