Administrator Mark, The Master Modeller Posted December 22, 2023 Administrator Share Posted December 22, 2023 Stage 78 gives us more of the bonnet structure, but we fit the rear frame. Offer the rear frame to the central body. The rear frame connects with 4 screws. Two at the bottom of the model. Two near the top of the rear frame. This should fit easily if you did the test fitting I suggested at the beginning of stage 75. Take the two upper tie rods that were supplied in stage 76. You need to identify which is left and which is right. Please them with the nut and bolt mouldings (as opposed to the bolt head) facing up. The upper rod is the left hand one. Take the right hand tie rod and insert the upper end in the slot in the top of the body. Insert the tab in the bottom end of the tie rod into the slot in the rear frame. The nut and bolt moulding must go to the inside. The bolt head points outside. Repeat with the left hand tie rod. This completes the stage. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.