Pack 9 - Stage 71. Radiator pipes.

[Mark, The Master Modeller]

Stage 71 gives us the cooling pipes for the radiator and the mounting stays.

Take the right pipe and push it into the hole in the right side of the radiator.

Now fit it over the pins on the bottom of the front subframe.  I found these to be quite stiff and needed a very firm push.

Take the left hand pipe and push it into the hole in the left hand side of the radiator.

Again, push the tabs on the pipe over the pins on the bottom of the subframe.  

Push the two radiator tie rods (stays) onto the radiator and front subframe.  These benefit from a drop of superglue as they tend to fall off with handling.

This completes the stage.