Pack 12 - Stage 97. Right side fairing.

[Mark, The Master Modeller]

Stage 97 gives us the right side fairing.

Assembly of this side is virtually the same as stage 96.

The brackets are all identified by their numbers engraved one the parts.

Fit the 4 brackets, upper bracket and front plate.  As with the left side plate, leave the brackets not quite fully tightened so that they can be twisted slightly to align the screw holes.

Put the fairing in place, clipping the upper edge over the chairs/chassis plate.

Fix the upper bracket with a screw fitted in the hole in the cockpit housing.

Fit the bottom brackets, twisting the brackets if necessary to align the screw holes.

Remove these two screws from the top of the wheel arches and replace them with the counter sunk screws SM supplied in this stage.  The round headed screws may stop the rear body closing properly.

This completes the stage.