Pack 10 - Stage 73. Right chassis plate and fuel pump.

[Mark, The Master Modeller]

Stage 73 gives us the right chassis plate and a fuel pump.

Note: Do not glue any of the pipe work as some of it is replaced in Pack 12.

Take the long fuel line and cut two lengths.  One 50mm long, the other 90mm long.

Fit the longer length to 2 pins on the chassis plate.

Fit the fuel pump to the protective shield.

Push the shorter length of fuel pipe onto the lower pin of the fuel pump.

Mount the fuel pump assembly on the chassis plate and connect the fuel pipe to the appropriate pin on the chassis plate.  You may need to scrape away the mould line on the bottom the protective plate.

Fit the braided fuel line to the pump fitting with the connector.

Push this onto the pin on the fuel pump.  Mine is quite loose and falls off easily, so you'll notice it missing in some of the subsequent photos.  As I mentioned, don't glue it yet.  

This completes the stage.