Pack 8 - Stage 39. More engine details.

[Mark, The Master Modeller]

Stage 39 gives us more details to be fitted to the engines.

Fit the 7 grips over the shafts.  The rearmost grip is for the centre prop shaft that isn't fitted yet, but the shaft will slide underneath it easily,

Take the turbine and condenser assembly and clip it in place, making sure that the seam pies locate with the steam pipes on the engine.

Take the central walkway and place it between the two engines.  Note how the tabs on the walkway fit into the slots on the engine standards.

Clip the walkway in position.  You shouldn't need any glue.

Task the various detail parts and fit them to the engine base.  They will need gluing in place.  The photo shows the port engine.  The starboard engine is a mirror image.  All the parts are identical except for parts 39F & 39G.  These should be fitted on the port and starboard engines respectively.

Take the pump detail and glue it to both the vapour separator and the top of the nearby pipe.  Repeat for the other engine.

Glue the shaft plate in position on the front of the engine.

This completes the stage.