Pack 8 - Stage 63. Front right upper wishbone.

[Mark, The Master Modeller]

Stager 63 gives us the from right upper wishbone, but we fit the front left upper wishbone provided in the previous stage.

Put the front upper wishbone in position.  Make sure you have the bolt details facing up.

Rotate the wishbone up so you can get to the slots where the supports will be fitted.

Fit the supports in the rectangular holes in the front subframe.  Note that the longer support goes toward the rear of the shock and the shorter bracket goes in front of the shock.  These are tricky to get into position, but a pair of tweezers will help.  

Secure them with screws when they are in position.

Take the torsion bar and push in into the hole in the from subframe.  Then push the other end onto the square post on the wishbone,

This completes the stage.