Pack 5 - Stage 36. Rear anti-roll bar.

[Mark, The Master Modeller]

Stage 36 gives us the rear anti-roll bar and its tie rods.

The right tie rod fits on the rear sub-frame as below.

The top end fits above the rear wishbone.

The front end fits in the front of the sub-frame.  This end just sits in a cut-out for the moment.

Repeat with the left tie rod.

The anti-roll bar needs to be clipped on to the tie rods fitted to the rear suspension in stages 26/27.  These are a right pain to fit as they are very tight!  I found it easier to remove the tie rods to clip them to the anti-roll bar.  Even then I had to use some smooth jawed pliers to get them to clip in.

Then I refitted the tie rods.  It's only 2 screws, so no great effort to remove and refit them.

Secure the anti-roll bar by pushing the brackets in place.

This completes the stage.