Administrator Mark, The Master Modeller Posted February 8, 2023 Administrator Share Posted February 8, 2023 Stage 32 gives us the left fuel tanks and the electronic circuit board. Nice to see that the circuit board extension leads are already connected. Place the board in position and fix it with 4 screws. Note that the plastic washers go under the screw heads. These are fiddly, but important as they ensure the screws don't cause any short circuits or over stress the circuit board. Lead the wires through the opening in the front of the tank. Push the top of the tank in place, being careful not to trap any wires. Push the filler pipe onto the top of the tank. Place the tank in position on the left side of the chassis. It fits from underneath and is secured with a single screw at the rear of the tank. I actually used the spare screw to hole the lug at the front of the tank, just to make it a little more secure during assembly, but this screw will need to be removed at some stage. This completes the stage. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.