Jump to content

Pack 11 - Stage 86. Left horizontal stabiliser.

Mark, The Master Modeller
 Share

Recommended Posts

  • Administrator
Mark, The Master Modeller Power Contributor

Mark, The Master Modeller

Posted
  • Administrator
Posted

Stage 86 gives us the left horizontal stabiliser and the engine frame cover.

P9161043.thumb.JPG.46e8b4d29c555e562ee02530f7af7d65.JPG

The horizontal stabiliser is glued in place. Test fit these parts to ensure they fit neatly before committing yourself with glue!

Apply superglue to the 5 pins on the lower surface, as identified in the instructions, and offer it up to the metal frame.

P9161044.thumb.JPG.d6ffb4d4a9a70c05d39830867a99fff7.JPG

Now fit the top surface and make sure it glues securely without leaving any gaps.

P9161045.thumb.JPG.096e3e0e5cc2cc7cf65c6fea9ee6dfe3.JPG

Moving on to the engine frame cover, temporarily remove the carb and air intake assembly. Then fit the engine frame cover in place with two screws.

P9161046.thumb.JPG.931e057873b18c93c853fb344a248b8a.JPG

Finally, replace the carb and air intake assembly.

P9161047.thumb.JPG.c12fe3760f3eaf936deb97c39b39896e.JPG

This completes the stage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...