Administrator Mark, The Master Modeller Posted November 28, 2022 Administrator Share Posted November 28, 2022 Stage 16 gives us the second set of velocity stacks and throttle bodies. Assembly is similar to the previous stage. Fit the flanges to the throttle body top. Fit the end caps. Screw the throttle bodies bottom in place. Now fit the alternator support arm. This is a push fit, but needed a firm push! There was a prominent mould mark on the support arm base, which I trimmed off and then repainted the bracket with some silver paint. Finally, fit the throttle bodies followed by all 6 velocity stacks. As before, these are secured with screws inserted through the exhaust port. This completes the stage. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.