Pack 3 - Stage 15. Velocity stacks (1)

[Mark, The Master Modeller]

Stage 15 gives us the first 6 velocity stacks and the throttle bodies.

Take the inlet flanges and fit them to the top of the throttle bodies top.  They are a press fit.

Add the two end covers to the underside of the throttle body top.

Take the throttle bodies bottom and screw it in place with 3 screws.  Make sure that the end caps are still in place.

Place the throttle bodies over the air intake brackets, then insert the first three velocity stacks.  They have a D shaped pin so they are correctly orientated.

These are secured by screws that are inserted through the exhaust port.

This completes the stage.