Pack 3 - Stage 20. The alternator.

[Mark, The Master Modeller]

Stage 20 gives us the alternator.

Attach the alternator mount to the engine block with a screw.

Press the two parts of the alternator together.  There is a pin on the cover and a corresponding slot in the base to make sure you get it aligned correctly.

Press the pin on the alternator into the bracket into the front of the engine.

Now rotate the alternator down and clip the two pins into the bracket you fitted at the start of this stage.

Put the fan over the pin of the drive belt.

Now press the drive belt into place.

Push the engine support into the hole just above the sump.  

This completes the stage.