Administrator Mark, The Master Modeller Posted November 14, 2022 Administrator Share Posted November 14, 2022 We need to centre the aileron servo before we can install the pushrod. Remove plug H1 (Top left hand side of the board) and plug it into the servo tester, then centre the servo. (Let's just pretend that the aileron pushrod isn't already fitted in the photo below..... 🤫) We need to unscrew the main circuit board so we can install the flap pushrod. Remove the 4 screws and gently ease the board away from the fuselage. There is no need to remove any wiring. The aileron pushrod was supplied in stage 58. Thread it through the hole in the aileron control arm. Fit the servo control arm onto the other end of the pushrod, then, while making sure the ailerons are in the neutral position, push it onto the servo and secure it with a screw. The cover was supplied in stage 57. Screw it in place. Now re-secure the circuit board and test the ailerons. P9070951.MOV This completes this stage. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.