Pack 8 - Stage 60. Drivers controls..

[Mark, The Master Modeller]

Stage 60 gives us the centre console facia, and the gear lever, hand brake and pedals.

Place the gear lever shroud (the chromed part, I'd call this the bezel or trim) on the bottom of the gear lever, then fit this to the facia.  It's fixed with a screw from the bottom.

Fit the pedals to the driver's footwell with a screw.

Make sure that the pin on the brake pedal moves freely through the hole.  Trim the hole a little if it sticks..

Fit the facial to the centre console/transmission tunnel.  This is held with three screws in the back.

The hand brake comes next.  This is also held by a screw.

Finally, fit the transmission tunnel to the floor.  This is also held by screws fitted from the back.

This completes the stage.