Pack 6 - Stage 48. Right aileron.

[Mark, The Master Modeller]

Stage 48 gives us the right aileron.

Take the aileron base and insert the three hinges.

Carefully screw the top half of the aileron base in place, being careful not to dislodge the hinges.

Take the right wing assembly and screw it to the wing root/left wing assembly.  It's fitted with 4 screws, and be careful not to trap any of the wires.

To make life easier and to reduce the risk of damaging the undercarriage doors, hold them closed with a piece of masking tape.

Fit the aileron base to the wing with 2 screws.  The outer end must clip into the slot in the wing.

Place the wire shaft into the hinges and put the lower half of the aileron in place.

Apply some tiny drops of superglue to the pins and fit the aileron top.  I always do a dry fit before committing myself with glue.

This completes the stage.