Pack 11 - Stage 92. Traffic cones, antennas, glass window and a replacement power board.

[Mark, The Master Modeller]

Stage 92 gives us 3 traffic cones, two antennas and the protective glass for the remote control.

We also get a replacement power board.

The two antennas screw into the rear of the turret.  They can be removed for storage.  Apologies for the poor quality photo.  The completed tank is just too big to photo on my work bench.

Peel the protective films off both sides of the glass.

Place this in the remote control casing.  You may prefer to leave this until the next pack as the glass is loose in the case until the remote control assembly ly is completed.

The new power board is a direct replacement for the old one.

Unplug the cables and remove the old board.  When you unplug the cables, pull them out by the plastic plug.  Don't just pull the cables as you risk pulling the cables out of the plug.

Fir the new board and secure with 2 screws.

Fit the battery cable in the left hand socket.

Fit the power cable in the right hand socket.

That completes this stage and this pack.