Administrator Mark, The Master Modeller Posted June 22, 2022 Administrator Share Posted June 22, 2022 Stage 3 gives us the beginnings of the dash. We also get a seat, but that isn't used yet. Fit the two main parts of the dash together, and secure with just one screw in the middle. Then turn it over and screw in two more screws from the underneath. Push the speedo and tacho in place. Note that our model is brand new, with zero miles on the clock. Push the instrument housing in place. This is a bit tricky, but it will go if you get it aligned squarely. You can push the pins on the lower dash inwards with a small screwdriver to persuade them to pop into their holes. Fit the two air vents. These just push in. It doesn't seem to matter which way round they go., This shot shows both vents in position. Remove the protective film from both sides of the instrument glasses. Push the glasses into place. They clip in without glue. This completes stage 3. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.