David Carr Posted December 29, 2021 Share Posted December 29, 2021 Hello all! Maybe I have a problem and maybe not. Agora support says no problem, but my gut with 50+years of modeling says otherwise. Laying this frame piece on a flat surface, the outer edge (will be below the lt door) of this area is bent upwards. The rt side is not like this. I now have the chassis assembled and the floor pans installed. And of course the left side is bent upwards following the frame below. The upper/ forward rt hand corner of the floor pan sits at 21/32" above the flat table top. The upper/forward lt hand corner on the opposite side is 24/32"! I attempted to include a photo but my computer skills will not let this happen. Do I panic over this? Quote Link to comment Share on other sites More sharing options...
Moderator AgoraSam Posted December 30, 2021 Moderator Share Posted December 30, 2021 Hi David, if you are really concerned then please contact us and we will check any details you have and send a replacement. Take care. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.