Hello all! Maybe I have a problem and maybe not. Agora support says no problem, but my gut with 50+years of modeling says otherwise. Laying this frame piece on a flat surface, the outer edge (will be below the lt door) of this area is bent upwards. The rt side is not like this. I now have the chassis assembled and the floor pans installed. And of course the left side is bent upwards following the frame below. The upper/ forward rt hand corner of the floor pan sits at 21/32" above the flat table top. The upper/forward lt hand corner on the opposite side is 24/32"! I attempted to include a photo but my computer skills will not let this happen. Do I panic over this?