General Lou Posted September 20, 2021 Share Posted September 20, 2021 This is the first stage, giving us 2 more lights for the base: These two LED lights follow the same assembly process as the lights in pack 11. So I place the LED circuit board into the holder with the lens, then thread the wire through the holding piece, incasing the LED. As stated by the instructions, the two LEDs are different, and it is important to know which is which after they have been built. Next, I use four screws to hold the back and front parts together. Finally, I thread the last part down the wire, and screw it on with a black screw and nut. I then repeat this for the other light: Stage complete: 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.