GTO 250 Pack 5 - Stage 36. Plug leads.

[Mark, The Master Modeller]

Stage 36 gives us the plug leads.  Be careful not to mix up the left and right lead connectors.

We only assemble the left leads in this stage.  Take the left connector and fit 6 of the shorter leads.

Find the distributor cap connectors from stage 19 and connect two of the longer leads.

Take four of the longer leads and fit them to the left hand distributor cap.

Take the connector with the short leads attached and fit it to the left hand cylinder head.  It should be a push fit, but you can use superglue to hold it if it's loose.

Now you can connect the 6 leads to the pins representing the tops of the spark plugs.

Now take the four longer leads from the distributor cap and connect them to the end of the connector.

The instructions tell you which leads goes where, which shows Agora's amazing attention to detail. However, it's a bit fiddly and I don't suppose anybody would notice if you didn't get them quite in the right order!

Push the distributor cap connectors onto the distributor cap and fit the two cables onto the remaining two pins on the connector.

This completes the stage.