Jump to content

Stage 76, Fitting the glovebox, radio and switches

Recommended Posts

This stage brings us one step closer to finishing the dash.


Start by adding the hinge joint to the glove box lid. Fix this in place with 2 BP screws, ensuring that they are not too tight and that the glove box lid has free movement. The next step is to add the lovely piece of stainless steel to the glove box lid. Peel the backing paper off, and carefully place this into position, then press it down firmly.


You'll need the dash board assembly for this next step. place the glove box interior then from the backside, position the Z shaped bracket over the two screw holes and secure with AP screws.


Next, slide the glove box lid into position from the front and screw it to the frame with 2 FP screws. (Don't worry if the lid doesn't close properly. The box interior might need a bit of repositioning, and a 3rd screw into the frame will get things sorted)


The next step is to add the 4 switches to the center console, followed by the radio face.


This completes this stage!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...