Pack 12 - Stage 96. Infrared Receiver & pedestal.

[Mark, The Master Modeller]

Stage 96 gives us the IR receiver unit and another piece of the pedestal.

Remove the two screws and the cover holder supplied in stage 89.

Screw the IR receiver circuit board to the cover holder.

Replace the cover holder.

Take the last section of pedestal base and put it in position.  It's secured with the metal plate.  The instructions advise adding this a little later on, but I found it more convenient to use it to hold the last section in place.  However, don't pick up the pedestal or you will bend the metal plate or damage the base.  

Add the side piece with the power switch, supplied in stage 71, and secure with the metal brackets supplied in stage 91.  

Screw the charging unit in place.  

It looks like this from the outside.  

This completes the stage.  It will be OK to pick up the pedestal now as the base is supported buy both the metal plate and the side piece.