Pack 8 - Stage 57. Right velocity stacks.

[Mark, The Master Modeller]

Stage 57 gives us the right hand velocity stacks.

Clip the injectors from the sprue.  I use a pair of sprue cutters as these give a nice clean cut.

Push the injector nozzles into the velocity stack panel.

Cut the fuel pipes into the various lengths detailed in the instructions.  I.e.  3x125mm, 135mm, 155mm & 160mm.  You can straighten them by dropping them in hot water if they are excessively curly.

Push the fuel pipes into the injectors and fed them through the holes in the velocity stack plate.

Temporarily remove the reinforcement bar 50B.

Put the velocity stack plate loosely in place.  Take the front three fuel pipes and clip them to the clips on the front of the cooling fan housing.

Clip them to the second clip on the fan housing.

Push the ends onto the connectors on the fuel injection pump.

Take the rear three fuel pipes and feed these round the back of the fan housing, clipping them to the clips.

Push these into the next three connectors on the injection pump.

Refit the reinforcement bar.

Push the velocity stack panel over the velocity stacks, being careful to make sure plug leads sit neatly between he velocity stacks and don't stop the panel sitting flat.

Push the 6 velocity stack covers in place.  

Followed by the 6 velocity stack necks.  Some of these needed a spot of superglue to hold them securely.

This completes the stage.