Help with pack 2

[Ajacobi]

Hey, I’m in need of a little help, I accidentally put the top of the shoulder on backwards and already glued the vents and the shield on over the screws, is there any way I can remove these parts so I could fix the mistake or am I either going to need to ask for a new pack 2 or just risk damaging the parts and wedge something underneath it and pulling it off?

[Mark A]

Try putting it all into a tub of water, then put it all into the freezer. The expanding water will often pop off glued parts without damage.

HTh!

 

Mark

[Ajacobi]

3 hours ago, Mark A said:

Try putting it all into a tub of water, then put it all into the freezer. The expanding water will often pop off glued parts without damage.

HTh!

 

Mark

Didn’t do the water part but world of wayne suggested the freezer part as well, I did just that and (aside from some in noticeable chips and a few scratches that are hidden under the detail parts and not visible) I was able to finally fix the issue, I appreciate the advice and will remember to try giving it a soak before the freezer next time, just freezing it alone took forever so I appreciate you letting me know of a way to speed up the process