Help with pack 2

[Ajacobi]

I need some advice/help with a mistake I made with my pack 2. I put the top of prime’s shoulder backwards and I have all the details glued on. Also I am curious about something else. For the sliding mechanism of the arm I am missing one of the 8 washers that acts as a stopper and wanted to know if that is a issue or going to be fine. Anyways, I need advice on how to safely remove the details covering the screws so I can fix the top part of the shoulder and also know if the arm is going to be fine without that washer

[Modellbau Schwaben]

Hello....
It would be helpful if you would show us a few pictures where exactly the problem is...
LG Thorsten

[Ajacobi]

12 minutes ago, Modellbau Schwaben said:

Hello....
It would be helpful if you would show us a few pictures where exactly the problem is...
LG Thorsten

Of course, I will take a few to show what I am talking about in a few

[Ajacobi]

32 minutes ago, Modellbau Schwaben said:

Hello....
It would be helpful if you would show us a few pictures where exactly the problem is...
LG Thorsten

Here is what I am asking about, I am missing one of 8 part TR-2-50, and the top vents are placed on backwards yet I placed the shield and back vent on and in doing so covering up the screws I’d need to remove to fix the problem. I am asking if I needed that last washer or if I will be fine? And also how I should remove the shield and vents in order to fix the top detail without damaging the model or the plastic parts?

[Modellbau Schwaben]

Hello... 
Such washers are available in every hardware store... 
Or ask a locksmith... They have them too. 
I would definitely use it

 

Buy yourself such a set. There are all sizes in it. You can always use it.

[Ajacobi]

1 hour ago, Modellbau Schwaben said:

Hello... 
Such washers are available in every hardware store... 
Or ask a locksmith... They have them too. 
I would definitely use it

 

Buy yourself such a set. There are all sizes in it. You can always use it.

and what of fixing the top vents? they are on backwards

[Modellbau Schwaben]

1 hour ago, Ajacobi said:

and what of fixing the top vents? they are on backwards

Since you can only very carefully dismantle again ... 
Depends on how much glue you have taken for the panels. If that doesn't work, politely ask customer service. 
Just tell it like it is that you made an assembly mistake.

[Ajacobi]

5 hours ago, Modellbau Schwaben said:

Since you can only very carefully dismantle again ... 
Depends on how much glue you have taken for the panels. If that doesn't work, politely ask customer service. 
Just tell it like it is that you made an assembly mistake.

Thankfully (after freezing the part for hours in the freezer) I was able to free them and fix the issue, a few tiny scuffs but nothing to noticeable