Pack 12 - Stage 93. The electronics.

[Mark, The Master Modeller]

Stage 93 gives us the electronic circuit board and wiring.

Firstly, plug the cables into the respective sockets in the circuit board.  These are numbered 01 to 07.

Note that the numbers on one side of the circuit board are 5 - 9 - 7.  Not 5 - 6 - 7 as you'd expect.  If you don't spot this you end up having to take the circuit board off again, correcting the wires and re-taking the photos...... 🤫

Screw the circuit board to the underside of the floor.

Now comes the 'fun' part.  Trying to get the floor in!  It does fit well, but it's a little reluctant to go in!

Start by sliding the front of the floor into the front of the car.  Make sure that the screw holes at the front line up.  One of the two is shown below.  Make sure you don't trap the wire 03 coming from the engine.  Mine is taped to the bell housing.

Now push the rear in place.  You'll find that the rear parcel shelf needs to be flexed a bit to get it past the boot hinges.  The photo below shows one stopping the parcel shelf fitting and the other has the shelf flexed past it.

The other place to take care is the fuel filler cover hinge.  The hinge must go through the slot in the floor.

Make sure all the screw holes are properly aligned and the floor should fit without any noticeable gaps.

Once you're happy, secure the floor with the 10 screws.

This completes the stage.