250 GTO Pack 5 - Stage 35. Oil Reservoir, filters and pump.

[Mark, The Master Modeller]

Stage 35 gives us the oil reservoir and associated components.

Fit the cover to the oil reservoir and fix it with a screw.

Fit the base to the oil pump.  This just rest in place and will be secured in the next step.

Screw the support bracket in place through the base of the oil pump.  The assembly is all secured now.

Cut the fitting from the sprue.  You need the one with two pins.  Then push the pipes onto the pins.

Now take two fittings with one pin and push them onto the other ends of the pipes.  Don't glue the pipes just yet as you may need to shorten the pipes.

Push the two filters onto the pump support bracket.  They should be a press fit, but you can use a spot of glue if necessary.

Fit the pipe assembly to the pump and filters as shown.  You may need to shorten one of the pipes a little to get a nice neat finish.

The reservoir fits on to the bottom of the chassis.

It's fitted from the top with a screw.

The oil pump & filter assemble is also fitted to the bottom of the chassis.

Again, fixed with a screw from above.

This completes the stage.