Chooksclan

Haha - that’s actually not my finger. I don’t wear nail polish - scouts honour haha. Got my daughter to do that - sheesh.

Hi, Having trouble Getting bonnet to sit right. Have attached the front End to the body and found the bonnet not aligned with guards. Have loosened the screws at front and under sides of windscreen to align correctly as shown in the instructions - that worked so that there is a really nice gap between guards and bonnet - BUT - the passenger side of the bonnet is slightly higher than the guard as it sits. I can press down so that it sits in but won’t stay. The second photo Is me pressing the hood down. Finger off and that side of the bonnet raises itself. I know the hood catches will probably hold it down but would prefer it to be square of course. Any tips?

Hi James, Thanks for the tip!! The pinion already on column so filing in situation will be ok I assume? I’ve been using a nail file til now - do you recommend a particular grade of file to use? Thanks in advance - and yes hopefully this will fix the Seating for the steering wheel as well. Chaooksclan

Hi Kitman and General I’m having the same problem. Couldn’t get the floor to fit with chassis after setting up steering column. Tried your resequence of floor then steering - now the fitting is very close but I can’t get the screw in to the top of column behind the dash. It’s almost like the steering column is about 1 and a half mm too long. I’ve tried to get the spindle further on to the shaft but to no avail. any other tips would be very welcome. thanks Chooksclan

I’d like to see some classic buses - Routemaster would be great, or any of the old streamlined classics - plenty to choose from I reckon I could leave it to the sharp eye of the agora team to pick a nice build.

Agora - if you decide to release the Routemaster outside of the UK please make sure you make it available in Australia. And if possible a twelve month subscription would be better. Currently enjoying the Supersnake build - very enjoyable and great quality.

I’m not sure if I should pull the seat trim off? I’m afraid I’ll rip it?

The drivers seat is fine. Don’t know why the passenger seat has the gap

Hi. Has anyone else had trouble with the rear upright of passenger seat? The front cushion of the rear section does not sit flush (at the bottom of the rear cushion) - there is a gap between the cushion and the seats plastic chrome frame. Annoying. Should I pull it apart to check all screws are home? I’m afraid I will tear the cushion in some way.