Pack 7 - Stage 48. Left tripod bar and tail lights.

[Mark, The Master Modeller]

Stage 48 gives us the rear light cluster and tripod bar.

Start by positioning the left tripod bar under the upper frame.  Insert all three screws loosely before tightening them up.  You may need to spring the tripod bar a little to get it to fit.

Here's a wider angle shot showing the tripod bar on the upper frame.

Insert the tail light lens in teh housing.  Note that the red brake light goes to the right.

Now screw the reflector in from the rear.

Screw the light cluster assembly to the upper frame.  The light cluster is angled outwards slightly.

This completes the stage, and this was when I decided to secure the bonnet lift arm with masking tape, because I got fed up with it falling about!