Pack 7 - Stage 46. Oil recovery tank, cooling duct and bonnet lift arm.

[Mark, The Master Modeller]

Stage 46 gives us the engine oil recovery tank, transmission cooling duct, bonnet lift arm and some other details.

Screw the two halves of the oil tank together.

Screw the strut to it with a couple of screws.

Fit the oil recovery hose to the back of the tank.  This just pushes on the pin, but you can superglue it if you wish.

Screw the support bracket to the first half of the cooling duct.

Now screw the two halves of the cooling duct together.

Push the trumpet onto the end.

Screw the two part sod the lift arm together.  Make sure that the bush on 46J is pointing outwards or you won't be able to fit the support bracket.

Fit the support bracket in place with a screw.  These parts should all be free to rotate.

This completes the stage.