Headlight & Minigum Mechanism

[Richard Gregory]

This is stage 96/98 step 22/19, both left and right headlight minigun mechanism. The instructions state that a DS02 screw should be used, I found this was to big and was cutting a thread in the plastic cap and did not bite into the metal. Using the smaller DS03 is a better fit and went straight into the metal housing.

I also put some grease on the headlight spring mechanism to try and make it a bit easier to push up and down when mount to the body.

[thomasparker046]

I think it might be an error as looking at the instructions the DS03 isn't used anywhere else