[My First Diary Posting]

I like the additions.  Keep us updated plz!  

[Recommended Change to Help Get a Better Fit on the Side Pipes]

The holes in each exhaust tube from the engine are 5/16" deep.  If I cut the 1'4" off each tube and cut down the pins on the exhaust pipes I can still join the two.  I'm going to eventually glue the headers to the engine heads anyway and headers to pipes, just too loosie-goosie for me as is anyway.   I will admit defeat and order new parts if I screw up!  

[Recommended Change to Help Get a Better Fit on the Side Pipes]

This caught my attention as I'm on pack 5 and ready to install the frt inner fender panels.  I'm thinking on maybe cutting off 1/4" (?) on the engine headers so not to have this issue later.   Am I going to make a big mistake here?  The connection to the outside exhaust will hook up the same.  

[Left lateral chassis main frame]

Hello all!  Maybe I have a problem and maybe not.  Agora support says no problem, but my gut with 50+years of modeling says otherwise.   Laying this frame piece on a flat surface, the outer edge (will be below the lt door)  of this area is bent upwards.  The rt side is not like this.  I now have the chassis assembled and the floor pans installed.   And of course the left side is bent upwards following the frame below.   The upper/ forward rt hand corner of the floor pan sits at 21/32" above the flat table top.  The upper/forward lt hand corner on the opposite side is 24/32"!   I attempted to include a photo but my computer skills will not let this happen.   Do I panic over this?