[Super Snake Pack 8 - Stage 61]

Hi James,

Thanks for the tip!!  The pinion already on column so filing in situation will be ok I assume? I’ve been using a nail file til now - do you recommend a particular grade of file to use?
Thanks in advance - and yes hopefully this will fix the Seating for the steering wheel as well.

Chaooksclan

[Super Snake Pack 8 - Stage 61]

Hi Kitman and General

 

I’m having the same problem. Couldn’t get the floor to fit with chassis after setting up steering column. Tried your resequence of floor then steering - now the fitting is very close but I can’t get the screw in to the top of column behind the dash. It’s almost like the steering column is about 1 and a half mm too long. I’ve tried to get the spindle further on to the shaft but to no avail.  
 

any other tips would be very welcome. 
 

thanks

Chooksclan

[Buses?]

I’d like to see some classic buses -

Routemaster would be great, or any of the old streamlined classics - plenty to choose from I reckon I could leave it to the sharp eye of the agora team to pick a nice build. 

[Hatchette 1/12 Routemaster Bus]

Agora - if you decide to release the Routemaster outside of the UK please make sure you make it available in Australia.

And if possible a twelve month subscription would be better. Currently enjoying the Supersnake build - very enjoyable and great quality.

[Super snake passenger seat]

I’m not sure if I should pull the seat trim off? I’m afraid I’ll rip it?

[Super snake passenger seat]

The drivers seat is fine. Don’t know why the passenger seat has the gap

[Super snake passenger seat]

Hi. Has anyone else had trouble with the rear upright of passenger seat? The front cushion of the rear section does not sit flush (at the bottom of the rear cushion) - there is a gap between the cushion and the seats plastic chrome frame. Annoying. Should I pull it apart to check all screws are home? I’m afraid I will tear the cushion in some way.