[Robert Richardson]

After viewing the response to the Mustangs doors being droopy and not lining up with the body,.

What size screws would you use, seeing that you are going to cross thread them, what then happens if the doors are still loose, you've already ruined the thread.  

I have only 1 step to go with this, and want to make it perfect. 

[Robert Richardson]

Good Afternoon.

Is there a solution to the problem of the (2)doors on the Shelby Mustang closing properly, they rattle quite a lot as if they are missing a couple of screws, instead of the ( 2) little pegs to hold a heavy door in position,

Hope you can advise.

Regards  

[Super Snake Pack 1 - Stage 3]

Unable to stop the doors from dropping , to much of a gape when closing the door, to much movement in the hinge letting the door drop.

There is only a single screw option holding the hinge, plus the two holding pegs.

I am up to the last stages in pack 12.  

[Super Snake Pack 7 - Stage 47]

Hi there, in the seventh diagram the screw at the rearmost position, the panel i have will not screw to the post,

there seems to be a gap of approx 3,4 mm where the screw goes through the end of the panel.

Has anybody mentioned this as it crucial to the fitment of the side panel.

Regards

Robert.

not sure how to inset image from URL.