T-800 Terminator Pack 11 - Stage 107

[General Lou]

Stage 107, covering up the circuits within the head, and building a light:

 

The battery unit from pack three sits snuggly on top of the head. I put the batteries in and make sure the switch is set to off before I put it inside.

 

These two rods connect the head and shoulders. They are difficult to screw in, so what i did was unscrew the top of the head as shown is the second image. This allows you to get to the screw holes easier. 

 

Next, I noticed that my wires where not connected, like they are shown to be in the instruction. Not to worry though as I just hooked them up here. Once connected, I glue magnets to the skull, and pushed on the skull plate. I am very impressed how the magnets create an easy access route to the brains.

 

Finally, I construct the light and have finished stage 107. 

 

Stage complete.