Shelby Cobra Pack 8- Stage 61 - 64

[General Lou]

The last four stages are all about connected parts to the firewall. Technically most of the parts seems to be "Electrical Device" !!!

 

Firstly the speaker, which will be used for the engine sounds, is attached to the back of the firewall.

 

The cable harness is fed across the top of the firewall and inserted into a section of holes. I did find that two of the holes were not wide enough to be able to pass the rubber through, this seemed to be due to excess paint from the spray painting being left inside the hole. It came off pretty easily when I twisted a screwdriver in the hole, however the first time I did it I made the hole marginally too big  so had to resort to a little bit of glue to hold the cable in place.

 

Once in place I cn then move on to inserting the various "electrical devices" and wiring them up.

 

Again, on for two of the holes contained excess paint this one had quite a lot to be removed so I used a knife

 

I worry that some of the rubber cables will come out once the model is completed and be. nightmare to get back into place, so decided to use a tiny bit of glue on the end of each cable to make sure it stays in place.

 

and here is my finished assembly:

 

Resting it in place at the end of the Pack....