Titanic Pack 16 - Stage 90. Details for the bridge deck.

[Mark, The Master Modeller]

Stage 90 gives us some more detail for the bridge deck.

Start by glueing the joining pieces in place with superglue.  These make the bridge deck assembly quite a lot more rigid.

Put the stair case in place and fix it with a couple of screws.  Note the two white pins on the deck that must fit in the holes in the staircase.

It looks like this from the top.

Stick the larger deck panel in place.  As before, I put some superglue on the outboard side of the deck to make sure it doesn't peel up.

The smaller deck piece is fitted centrally.  This will be held down by the superstructure so no need to worrk about superglue.

As before, the window frame need gluing to the bulkhead with tiny amounts of super glue.

Here are some close-ups of some of the windows.

The central window frame needs bending slightly.  gently bend it over a large screwdriver shaft or similar.  I didn't realise mine was crooked until I saw the photo.  Close-ups can be so cruel!!

Fit the four connectors to the bulkhead.

Now fit the bulkhead to the deck with four more screws.

It looks like this from the pretty side.

Finally, turn the deck over and fit the LED board.

This completes the stage.