Jump to content

Recommended Posts

  • Administrator
Posted

Stage 24 gives us another section of hull and the port anchor.

P3020836.thumb.JPG.1bba69ae90e41a86e9745d84e99cf6bd.JPG

Firstly, remove the starboard bulwark.

P3020838.thumb.JPG.13d3a510d3fc5f90a2f4601dc27185a4.JPG

Fit the hull section in place.  It's secured with a total of 5 screws.

P3020840.thumb.JPG.ea1e56825e209176cafc28077656c4c8.JPG

Replace the bulwark.

P3020841.thumb.JPG.7a779ffbfbf48459b91ea40412ed6e69.JPG

Feed the anchor chain through the port hawse hole.

P3020842.thumb.JPG.7684703657c1e2e977c2ae3992b2cd73.JPG

Now feed it over the two rods.

P3020843.thumb.JPG.23ac4d484dc61a856f6dc349d3f1e154.JPG

Clip the end of the chain to the clasp on the winch cable.

P3020844.thumb.JPG.8edaa95b0687d4718f126042f0ced410.JPG

Gently pull out the anchor and release it.  It should retract back into the hawse hole.

If the top of the anchor hangs below the hawse hole, remove the lid of the winch housing, gently prise out the motor and wind a turn of the rope back on the wish drum.  Then replace it and try again.

 

 

This completes the stage.

P3020849.thumb.JPG.51280fd96dcede265b62a15fb5962043.JPG

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...