Pack 4 Stage 33. Rear left brake.

[Mark, The Master Modeller]

Stage 33 gives us the rear left brake disc and caliper.

Push the two halves on the brake disc together.

Now we fit the inside half of the caliper.  I needed to scrape the paint off the pins, and also drill out the excess paint from the holes in the caliper.  A 1.6mm drill did the trick.  Don't worry if it becomes a loose fit and you can always glue it in place.  It's better to glue it that it is to break it by pushing too hard if the fit is too tight!

Put the disc in place.

Now push the outer half of the caliper in place.  This went on easily.

This completes the stage and the pack!