Pack 4 - Stage 31. Exhaust manifold (III).

[Mark, The Master Modeller]

Stage 31 gives us the last part of the exhaust manifolds, including the silencers.

Place the bottom of the first silencer half on the support shield ensuring that the manifold pipe is properly located in its cut-out.

Put the top half of the silencer in place and fix it with a screw.  Make sure that the front manifolds are properly located in the engine block.

Put the exhaust pipe, supplied in this stage, in position and screw it to the rear exhaust manifolds.

Place the bottom half of the second silencer in position, making sure that the pipe is in its cut-out. Check that the rear manifold is still sitting in the holes in the engine case.

Screw the top half of the silencer in place.

Now you can glue the exhaust manifolds into the engine casing if necessary.  Just pull them away from the casing a little, apply a drop of superglue with a cocktail stick and push the manifold back in place, holding them for a minute wheel the glue cures.

This completes the stage.