Pack 3 - Stage 21. Clutch cover.

[Mark, The Master Modeller]

Stage 21 gives us the clutch bell housing and control lever.

Press the clutch bell cover onto the bell housing.  Remove any flash from the pins first.

Push the clutch bell housing assembly onto the rear of the engine.

Push the clutch slave cylinder onto the engine block.  Note that the correct orientation in the photo below.

Take the control arm and fit it to the bell housing and the slave cylinder.  It will only go one way round.

Fit the clutch spring between the cylinder and the control arm.  A pair of pointed tweezers is helpful, but you can use a cocktail stick if you don't have suitable tweezers.

Now place the cover over the control arm.  It's a shame to cover this detail, but we know it's there......

This completes the stage.