Jump to content

Stage 66 - Assembling the lifting device.


Recommended Posts

  • Administrator

Stage 66 gives us parts for the lifting device and the remote control.

P9070903.thumb.JPG.e65f38b3e4e68098145cce7089a2d7c4.JPG

Fit the slider assembly to the lifting device base that was supplied in stage 63.

P9070904.thumb.JPG.37ea74137549aab34bd4efd60854e7f5.JPG

Fit the lifting device frame over the top, making sure that the shafts are inserted properly.

P9070906.thumb.JPG.e41bbd5ce6303df6ce5ec6caec024fb3.JPG

Insert the perspex support bar and secure the frame with 6 screws.

P9070909.thumb.JPG.6e36c64606ec3f6041cd2ba62b513439.JPG

Slide the limit switch assembly over its bracket and check that the limit switches give a nice positive click when the slider is raised and lowered.  You may need to move the limit switches a little.  Loosen the screws holding the limit switch and raise or lower it.  The limit switches are held with slotted holes to allow adjustment.  If you still can't get a click, remove the limit switch and place a card spacer under it to move it out a bit.

P9070911.thumb.JPG.26f6e78ffecf077e5ff4e22222e4f2f8.JPG

Finally, and not mentioned in the instructions, remove the film from the remote control.  

 

Very satisfying (and apologies for the background noise!)

This completes the stage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...