Jump to content

Pack 7 - Stage 54. Rudder servo

Mark, The Master Modeller
 Share

Recommended Posts

  • Administrator
Mark, The Master Modeller Power Contributor

Mark, The Master Modeller

Posted
  • Administrator
Posted

Stage 54 gives us the rudder servo.

P8220809.thumb.JPG.54448f138aa44c70e8b4ef0dfb468270.JPG

All we do is test the servo with the tester that was supplied in stage 53.  However, I did need the adapter cable that is supplied in stage 59.

Connect the battery box, tester, adapter cable and servo as shown below.

P8220830.thumb.JPG.b69be68d7fc73998a2135621184132de.JPG

Now you can test your servo.  The rotate button swings the arm left and right, and the zero button sets the servo to its neutral position.  You should set it to its neutral position before connecting the servo arm when you install the servo in the model.  That was the control surfaces should be straight.

 

That completes this stage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...